Home >Products >

Products

Case

sludge thickner retention time

2018-08-14T00:08:14+00:00
  • Recuperative thickening for sludge retention time and ...

    This study evaluated the application of recuperative thickening (RT) to enhance anaerobic digestion (AD) performance for AD systems with thermal hydrolysis

  • Exam Study Guide: Sludge Detention Time Treatment Plant ...

    Sep 11, 2014  If the sludge is pumped from the bottom of the unit at a rate of 20 gpm, what is the sludge detention time (in hours) in the thickener? A) 13.5 hours B) 17.3

  • Estimated Reading Time: 1 min
  • Recuperative thickening for sludge retention time and ...

    Sep 17, 2019  Recuperative thickening for sludge retention time and throughput management in anaerobic digestion with thermal hydrolysis pretreatment. Baoqiang Li, Corresponding

  • Cited by: 3
  • Sludge Thickening - an overview ScienceDirect Topics

    The concentration of nitrate denitrified increases as (1) sludge retention time in the SST increases, which is dependent on the recycle ratio and peak flow

  • Sludge Retention Time Control System Aids Wastewater ...

    Sep 01, 2002  Sludge wasting using solids retention time (SRT) criterion is based on the fact that constant SRT leads to constant F/M. The waste flow is usually a small fraction

  • Estimated Reading Time: 6 mins
  • CHAPTER 3 SLUDGE THICKENING - Marmara

    The thickening process takes place in a settling tank with long-enough solids retention time. For example in secondary clarifiers of activated sludge systems

  • File Size: 697KB
  • Recuperative thickening for sludge retention time and ...

    This study evaluated the application of recuperative thickening (RT) to enhance anaerobic digestion (AD) performance for AD systems with thermal hydrolysis pretreatment (THP). RT was applied for two different reasons: (a) for increasing the sludge retention time (SRT) to degrade slowly hydrolyzable

  • Recuperative thickening for sludge retention time and ...

    Sep 17, 2019  Recuperative thickening for sludge retention time and throughput management in anaerobic digestion with thermal hydrolysis pretreatment. Baoqiang Li, Corresponding Author. [email protected]; George Washington University, Washington, District of Columbia. DC Water, Washington, District of Columbia.

  • Sludge Thickening - an overview ScienceDirect Topics

    The concentration of nitrate denitrified increases as (1) sludge retention time in the SST increases, which is dependent on the recycle ratio and peak flow conditions; (2) active fraction of the sludge increases, that is, greater at shorter sludge ages (Figure 15); (3) temperature increases; and (4) mass of unutilized enmeshed biodegradable ...

  • sludge thickner retention time - casa21.be

    Sludge thickening on the device is aided by multiple rows of plows and drainage elements which slow the flow of sludge and provide additional retention time over the horizontal gravity belt. GBTs generally require a smaller footprint than other sludge thickening processes, are cost-effective and use less energy than other mechanical thickening ...

  • Ekster and Associates SRTMaster - SRT Control

    conditions for thickening of the wasted sludge. SRTmaster™ controls sludge retention time (SRT) also known as sludge age. It does this by using a sophisticated control algorithm that takes into account real time variations in solids inventory in the aeration tanks and in solids to be wasted.

  • Sludge Retention Time Control System Aids Wastewater ...

    Sep 01, 2002  Sludge wasting using solids retention time (SRT) criterion is based on the fact that constant SRT leads to constant F/M. The waste flow is usually a small fraction of the influent flow; however, minimal variations of waste flow over time may have a profound effect on the performance of an activated sludge system.

  • TECHNOLOGY FACT SHEETS FOR EFFLUENT TREATMENT

    SLUDGE THICKENING FS-FNG-001 Page. 7 of 31 Hydraulic retention time: * 4 6 L 8 3 L D 3 Where: HRT = hydraulic retention time (hours) h = water depth under weir (m) V = net thickening volume (m3) Factors determining the gravity thickening unit operation are as follow: Sludge origin and characteristics. Flocculation nature.

  • CHAPTER 6: DESIGN AND CONSTRUCTION OF SLUDGE

    sludge moisture content, retention time, etc., and is based on the solids balance of the entire sludge treatment facility. The solids balance considers the reduction due to gasification, return load from ... • Thus, the solids load entering the sludge thickener becomes 112.1

  • Design Guidelines For Sewage Works: Sludge thickening and ...

    Mar 29, 2019  Sludge thickening on the device is aided by multiple rows of plows and drainage elements which slow the flow of sludge and provide additional retention time over the horizontal gravity belt. GBTs generally require a smaller footprint than other sludge thickening processes, are cost-effective and use less energy than other mechanical thickening ...

  • Water Handbook - Wastewater Treatment SUEZ

    The retention time is a function of tank depth. ... and excessive sludge retention in the clarifier. Various chemical treatment programs are described below. ... return of steel mill thickener sludge to the sinter plant, and marketing of by-product metallic salts for wastewater treatment use.

  • Thickening – Giotto Water

    The sludge is delivered to the external mixer to be conditioned with chemicals and then discharged inside the thickening drum. The drum consists of 4 zones separated by anular rings, each of which has an adjustable opening to adapt the sludge retention time according with its characteristics.

  • Technological Improvements for the Aerobic Digestion of Sludge

    Aug 22, 2001  Duration of thickening should be 3 to 5 hours with a concentration of thickened sludge 10-13 g/L. By using this scheme, the detention time of activated sludge aerobic digestion should be 5-8 days with the air rate 1 m3/m3 of activated sludge in one hour. Sedimentation time of digested sludge is

  • (PDF) Simulation and assessment of sludge concentration ...

    Key words: membrane filtration; membrane fouling; sludge thickening; sludge digestion; waste activated sludge DOI: 10.1016/S1001-0742(08)62467-5 Introduction time (SRT) with gravity thickening process, lower quan- tity of sludge storage and higher energy cost with DAF It is widely accepted that conventional activated sludge thickening compared ...

  • DOCUMENT' RESUME SE 041 599 AUTHOR Klopping, Paul H ...

    eration in thickening secondary sludge. 10. Explain why filamentous bacteria in secondaey sludge causes thickening problems. 11. Recall that an increase in temperature causes an increase in biological activity. 12. Recall that gravity thickener operation varies between. summer and. winter due to the effect of temperature on gasification. 13.

  • Effect of blending process on retention time for sludge ...

    In this paper, we study the effect of using dilution water (effluent water from Al Gabal Al Asfar wastewater treatment plant) on the retention time of the gravity thickener. The results explained that it is not suitable to increase the retention time in the gravity thickener when mixing the primary and secondary sludge and when adding the ...

  • Recuperative thickening for sludge retention time and ...

    Sep 17, 2019  Recuperative thickening for sludge retention time and throughput management in anaerobic digestion with thermal hydrolysis pretreatment. Baoqiang Li. Corresponding Author. E-mail address: [email protected] George Washington University, Washington, District of Columbia.

  • SRTmaster - Controls Sludge Retention Time (SRT) Software ...

    Sludge Retention Time (SRT) Software. SRTmaster maintains the optimum environment for microorganisms in an activated sludge system and optimum conditions for thickening of the wasted sludge. SRTmaster controls sludge retention time (SRT) also known as sludge age. It does this by using a sophisticated control algorithm that takes into account ...

  • Nutrient Optimization in Activated Sludge wwtps

    Mar 10, 2021  Retention time enough to remove ammonia. Enough BOD to support bacteria growth. Optimizing Bio -P Removal: Mainstream or Sidestream Fermentation. Anaerobic Tank. 2 hour HRT (hydraulic retention time)* ORP of -200 mV* 25 times as much BOD as influent ortho-P* ... Thickener. Sludge

  • Water Handbook - Wastewater Treatment SUEZ

    The retention time is a function of tank depth. ... and excessive sludge retention in the clarifier. Various chemical treatment programs are described below. ... return of steel mill thickener sludge to the sinter plant, and marketing of by-product metallic salts for wastewater treatment use.

  • Thickening – Giotto Water

    The sludge is delivered to the external mixer to be conditioned with chemicals and then discharged inside the thickening drum. The drum consists of 4 zones separated by anular rings, each of which has an adjustable opening to adapt the sludge retention time according with its characteristics.

  • Influence of Temperature, Agitation, Sludge Concentration ...

    May 10, 2012  The aim of this research was to determine the influence of temperature, agitation, sludge concentration, and solids retention time (SRT) to obtain readily biodegradable organic matter on primary sludge (PS) fermentation, which would be used as substrate in a biological nutrient removal (BNR) process. Stirring and heating the sludge as well as increasing SRT improved the PS

  • Anaerobic Sludge Digesters: Capacity and Elements Waste ...

    In the anaerobic digesters without recycle, the solids retention time (SRT) is equivalent to the hydraulic retention time (HRT), i.e., volume of digester/volume of sludge withdrawn per day. Table 16.4 also gives typical values of solids retention time (SRT) and hydraulic retention time

  • Sludge membrane thickening and MBRs: how thick is ...

    Jun 29, 2020  What is clear, though, is that at the sort of solids concentrations used in membrane thickeners – well above 20 g/L – the apparent viscosities are significantly higher than for MBR sludges. This has been confirmed from many practical verification studies of viscosity, as summarised by Hong et al (2018). sponsored.

  • UNDERSTANDING POLYMER FOR THICKENING AND

    However, this polymer type requires more equipment and time to prepare (or activate) the polymer. It is the active content that should be considered when assessing appropriate polymer dosages for solids processing systems. The best way to think of polymer dose for thickening

  • Sludge Thickening - an overview ScienceDirect Topics

    Sludge Thickening. Sludge thickening is a process in which the solids concentration is increased and the total sludge volume is correspondingly decreased, but the sludge still behaves like a liquid instead of a solid. Thickening commonly produces sludge solids concentrations in the 3% to 5% range, whereas the point at which sludge begins to ...

  • Sludge Thickener - Rexon Associates

    HEI thickeners are constructed with flat bottoms and heavy duty rake drive mechanisms to move the sludge to the center outlet. The flat bottom cylindrical thickener provides 3 times the volume of an equivalent cone and, hence, 3 times the retention time.

  • (PDF) Simulation and assessment of sludge concentration ...

    Key words: membrane filtration; membrane fouling; sludge thickening; sludge digestion; waste activated sludge DOI: 10.1016/S1001-0742(08)62467-5 Introduction time (SRT) with gravity thickening process, lower quan- tity of sludge storage and higher energy cost with DAF It is widely accepted that conventional activated sludge thickening compared ...

  • DOCUMENT' RESUME SE 041 599 AUTHOR Klopping, Paul H ...

    eration in thickening secondary sludge. 10. Explain why filamentous bacteria in secondaey sludge causes thickening problems. 11. Recall that an increase in temperature causes an increase in biological activity. 12. Recall that gravity thickener operation varies between. summer and. winter due to the effect of temperature on gasification. 13.