Home >Products >

Products

Case

effect of ph on pper flotation cell machine

2018-11-01T21:11:17+00:00

Effect of pH on Copper Cleaner Flotation (after Regrind ...

Oct 01, 2015  Accordingly, higher pH levels were adopted for cleaner flotation to enhance selective flotation of copper VS pyrite. Concentrate regrinding to a product size of 80% passing 30 µm is adequate to yield, after three stages of cleaning at pH 11-12, a final concentrate assaying 31% copper. Cleaner times in the laboratory were short, at 3 minutes ...

Estimated Reading Time: 3 mins

The Importance of pH in Flotation

Aug 10, 2015  The Importance of pH in Flotation. In flotation, pH control is a vital method to control selective mineral separation. A standard depressant that is used is an Alkali. An Alkali is any substance that when mixed with Acid will neutralize each other and form a new chemical substance called a BASE. This is very important.

Estimated Reading Time: 9 mins

Critical importance of pH and collector type on the ...

Feb 04, 2021  The flotation tests were performed in self-aerated Denver flotation machine with a 2.3 L cell and agitation speed was adjusted to 900 rpm. ... Lead flotation stage Effect of pH on the grade and ...

Cited by: 1

Effect of pH on the Recovery and Grade of Base Metal ...

Abstract—This study investigated the effect of pH on the recovery and grade of the Platinum Group Metals (PGMs) and base metal sulphides from the UG2 ore of the bushveld complex. This was achieved through running a series of test work in a Denver flotation cell at varying pH 6-11 at constant reagent dosage. The UG-2 reef is characterized by two

File Size: 542KB

THE EFFECT OF COPPER SULPHATE ON FROTH STABILITY

THE EFFECT OF COPPER SULPHATE ON FROTH STABILITY Wadzanai Nyabeze BSc(Eng) in Chemical Engineering, University of Cape Town ... The decrease in froth stability could have an effect on the overall flotation performance as a result of possible activation of gangue minerals by copper sulphate . Page v ... 4.3.1 Effect of pH on the zeta potential ...

The impact of water quality on flotation performance

The impact of water quality on flotation performance pH, Eh, DO and dissolved species in recycle water streams (e.g. thickener overflow, decant (tailings) dam return) contributing to a circuit water are also shown in Table I. TDS and TOC levels may also be raised by reagent addition for pH control (e.g. lime) and recycled organics (e.g ...

Effect of pH on Pulp Potential and Sulphide Mineral Flotation

Control of pH is one of the most widely applied methods for the modulation of mineral flotation. In this study the effect of pH on potential in solution and sulphur minerals flotation is discussed with various electrodes. The electrodes were platinum, gold, chalcopyrite, pyrite and galena. In solution, potentials were linearly dependent on pH with a different slope for each electrode.

Effect of copper ions on the flotation separation of ...

Jan 01, 2018  Flotation separation tests were implemented with the aid of an XFD III flotation machine equipped with a 1 L flotation cell, manufactured by Jilin Prospecting Machinery Factory, China. During the conditioning process, the pulp was prepared with 350

7 Factors Affecting Froth Flotation Process - JXSC Machine

Grinding Particle Size. Both large ore particles (larger than 0.1mm) and small ore particles (less

Flotation of Nickel-Copper Sulphide Ore: Optimisation of ...

All the flotation test-work was done using the Denver laboratory machine with a 1.5l stainless steel flotation cell. The required mass of nickel-copper sulphide ore material ground to 70% passing 75 µm was weighed and placed in the flotation cell. This was followed by the addition of distilled water to about

Recovery of copper and cobalt in the comparative flotation ...

effect of pH on the flotation is proposed. Some parameters were ... rpm), a flotation machine DENVER, flotation cell of 2.5 L, panels, an VIBRA electronic balance, graduated vessels for reagents, a pH meter, a propipette, a wash bottle of 1 liter, a ... natural pH, copper recovery is fast with DANA until the fifth minute. After the fifth minute ...

Effects of Collectors and Frothers on Copper and ...

May 14, 2019  These physical parameters are the following: liberation, turbulence in the flotation cell, pH, collector, frother type and dosage. The testwork discussed in this paper was performed for a copper-molybdenum operation that is experiencing coarse particle (>150 μm) losses in the tails.

Effect of pH on the Recovery and Grade of Base Metal ...

Abstract—This study investigated the effect of pH on the recovery and grade of the Platinum Group Metals (PGMs) and base metal sulphides from the UG2 ore of the bushveld complex. This was achieved through running a series of test work in a Denver flotation cell at varying pH 6-11 at constant reagent dosage. The UG-2 reef is characterized by two

Removal of Copper from Industrial Wastewater by Ion ...

floatability of copper in pH = 4.0, 0.5% Ethanol, air flow rate: 50 ml/min. 3.4 Frother effect Figure 3.4 illustrates copper flotation in the presence of air flow rate of 50 ml/min and various concentrations ethanol, of as frother. It is clear to see that after 20 minutes of flotation, the highest value of the removal of 71% at ethanol 0.1%.

RECOVERY OF COPPER FROM OXIDE COPPER ORE BY

ground particles under microscope. During the flotation tests; the effects of type and dosage of collectors, pH, and dosage of activator Na 2 S were examined. Results of flotation tests were unsuccessful in terms of both recovery and grade of concentrate product. The highest copper recovery of concentrate was found as 61.35% with

Recovery of Copper from Cyanidation Tailing by Flotation ...

Dec 10, 2015  Effect of Copper Sulfate on Copper Recovery in the Flotation Process. The effect of copper sulfate on copper recovery were studied at pH 9.8–10.2, xanthate concentration 6.66 × 10 −5 mol/L as collector and 2# oil concentration 10 mg/L as frother. The activation time was fixed at 3 min.

(PDF) Parametric Optimization in Rougher Flotation ...

Jul 26, 2020  The main factors influencing the copper flotation process and their levels. ... 10 g/t). After 1 min, flotation cell . ... frother > quadratic effect of pH > interactive effect between collector ...

Effect of bacterial conditioning and the flotation of ...

copper in 9K was increased up to 1 g/l, at end of the adaptation process. Flotation Tests The flotation tests were carried out in a Hallimond tube and Denver type flotation machine. In Hallimond tube tests, 1 g sample was used having –210+38 µm. In the study of

The effect of biopolymer dispersants on copper flotation ...

Oct 01, 2016  Copper recovery increased from 85% to 90%, 94% and 93% at the end of flotation, in the presence of DP-1777, DP-1775 and DP-1778, respectively. DP-1775 and DP-1778 had a better effect on copper recovery than DP-1777. The presence of biopolymers also led to an increase in flotation rate, seen as the higher copper recoveries in the first concentrate.

Common Questions About Froth Flotation Process Technology

Apr 17, 2019  For example, a certain copper-cobalt oxide ore in Congo, whose main copper content is malachite, and cobalt mineral is cobalt hydrate, is used to improve the flotation effect. After the experiment, sodium hydrosulfide and ammonia sulfide are used in a ratio of 1 to 1 to improve the flotation effect. 2. Flotation cell foam, reflective surface

Feasibility Study of Differential Flotation of Cu–Pb–Zn ...

Aug 28, 2020  In this research, flotation of copper, lead and zinc minerals from a copper oxide–sulfide ore was studied. The identification tests showed that the sample is a mixture of quartz, chalcopyrite, galena, cerussite, hemimorphite and iron oxide minerals with 5.04% CuO, 1.61% PbO, 2.07% ZnO and 56.40% SiO2. The experimental design methodology (RSM) was conducted to investigate the effect

1 Froth Flotation – Fundamental Principles

no flotation can occur. Contact between particles and bubbles can be accomplished in a flotation cell such as the one shown schematically in Figure 5. Figure 5: Simplified schematic of a conventional flotation cell. The rotor draws slurry through the stator and expels it to the sides, creating a suction that draws air down the shaft of the stator.

Minerals Free Full-Text The Effect of Sodium Alginate ...

The single mineral flotation tests were conducted in an XFGC mechanical agitation flotation machine at 1992 rpm with a 40-mL cell. For single mineral flotation, 2 g of pure mineral was added into the flotation cell with 40 mL of distilled water. The pH was adjusted to the desired value (2, 4, 6, 8, 10, and 12) using NaOH or HCl within 3 min.

Floatability and Bubble Behavior in Seawater Flotation for ...

This study has shown that about 92 % of copper can be recovered with a maximum copper grade of 4.2 mass% in a froth after 15 minutes of flotation at pH 8.5 when used potassium amyl xanthate as a ...

The Importance of pH in Flotation

Aug 10, 2015  The Importance of pH in Flotation. In flotation, pH control is a vital method to control selective mineral separation. A standard depressant that is used is an Alkali. An Alkali is any substance that when mixed with Acid will neutralize each other

Effect of pH on the Recovery and Grade of Base Metal ...

Abstract—This study investigated the effect of pH on the recovery and grade of the Platinum Group Metals (PGMs) and base metal sulphides from the UG2 ore of the bushveld complex. This was achieved through running a series of test work in a Denver flotation cell at varying pH 6-11 at constant reagent dosage. The UG-2 reef is characterized by two

Critical importance of pH and collector type on the ...

Feb 04, 2021  The flotation tests were performed in self-aerated Denver flotation machine with a 2.3 L cell and agitation speed was adjusted to 900 rpm. ... Lead flotation stage Effect of pH on the grade and ...

How Does Pulp Concentration And pH Affect Froth Flotation ...

Sep 20, 2019  In froth flotation process, the pH value of the pulp needs to be paid close attention to at all times. The pH value needs to be measured with a test paper every once in a while to ensure that the pH value remains at a stable value. And the pulp concentration and liquid level need to be stable, ensure scraping, foam to scrape out the full plate.

Effects of Collectors and Frothers on Copper and ...

May 14, 2019  May 14, 2019  Typically, coarse dense mineral particles greater than 150 μm are difficult to float, and the recovery decreases progressively. Various physical parameters can be manipulated in an attempt to increase the recovery. These physical parameters are the following: liberation, turbulence in the flotation cell, pH, collector, frother type and dosage.

The impact of water quality on flotation performance

The impact of water quality on flotation performance pH, Eh, DO and dissolved species in recycle water streams (e.g. thickener overflow, decant (tailings) dam return) contributing to a circuit water are also shown in Table I. TDS and TOC levels may also be raised by reagent addition for pH control (e.g. lime) and recycled organics (e.g ...

Effect of Eh and pH on the flotation of enargite using ...

Dec 01, 2020  It is well known that the electrochemical reactions that take place on the surfaces of metal sulfides, which can lead to surface oxidation, have a strong effect on the flotation efficiency ().In order to standardize the physicochemical conditions of the pulp fed to the microflotation cell, the E h and pH values were strictly measured and controlled.

Effects of Collectors and Frothers on Copper and ...

The flotation tests were performed using a Denver laboratory machine with a 2 litre cell. The flotation testwork was based on the procedure indicated by the concentrator that provided the ore for testing. In all the flotation tests, concen-trates 1, 2, 3 and 4 were collected for 45 seconds, 1.25 minutes, .0

Effect of copper ions on the flotation separation of ...

Jan 01, 2018  Flotation separation tests were implemented with the aid of an XFD III flotation machine equipped with a 1 L flotation cell, manufactured by Jilin Prospecting Machinery Factory, China. During the conditioning process, the pulp was prepared with 350

Effect of pH on Pulp Potential and Sulphide Mineral Flotation

Control of pH is one of the most widely applied methods for the modulation of mineral flotation. In this study the effect of pH on potential in solution and sulphur minerals flotation is discussed with various electrodes. The electrodes were platinum, gold, chalcopyrite, pyrite and galena. In solution, potentials were linearly dependent on pH with a different slope for each electrode.

Improve Copper Production by Controlling PH in Flotation ...

Mar 16, 2015  Mar 16, 2015  If pH is too low, iron will likely be entrapped in addition to copper, decreasing the value with the copper ultimately recovered. If too much lime is added, the effect can be a dilute froth pots additional concentration in later phases, increasing operating costs and wasting lime. Xinhai flotation process is customized according the requirement ...

7 Factors Affecting Froth Flotation Process - JXSC Machine

Dec 20, 2018  Froth Flotation machine plays an indispensable role in the mineral beneficiation process, flotation is susceptible to a number of factors during the process, including grinding fineness, slurry concentration, pulp pH, pharmaceutical system, aeration and agitation, flotation time, water quality and other process factors. The factors that affect ...

Flotation of Nickel-Copper Sulphide Ore: Optimisation of ...

All the flotation test-work was done using the Denver laboratory machine with a 1.5l stainless steel flotation cell. The required mass of nickel-copper sulphide ore material ground to 70% passing 75 µm was weighed and placed in the flotation cell. This was followed by the addition of distilled water to about

Flotation of oxide copper ore with sodium oleate from the ...

using a Denver machine (Denver D-1, Serial no.7627-001) with a cell volume of 1000 mL operating at a fixed agitation speed of 1000 rpm in all experiments. A variety of industrial-grade chemical reagents were used in the flotation of oxide copper ore: hydrochloric acid (HCl) and sodium carbonate (Na 2 CO 3) were used as pH regulators.